02 – Vespa Sprint 125 – 4T 3V iGet – Euro4 – ABS – 2016-2020 – ZAPMA1300 / ZAPMA1301 – Crankcase

These fitting bushings or reference plugs help to be able to press two parts together in the right place so that the holes align neatly. So they act as reference points.

Diameter 9.5 mm, opening 6.5 mm, length 15 mm.

Mounts on virtually all Vespa and Piaggio scooters, in various locations.

But to be sure, check the list below to see if they are on your model in these sizes.

These fitting bushings or reference plugs help to be able to press two parts together in the right place so that the holes align neatly. So they act as reference points.

Diameter 11 mm, opening 8.1 mm, length 10 mm.

Mounts on virtually all Vespa and Piaggio scooters, in various locations.

But to be sure, check the list below to see if they are on your model in these sizes.

This silentbloc reduces the vibrations transmitted by the block to the frame, preventing unnecessary wear, rattling noise and increasing riding comfort.

You will need two!

Length 30mm, diameter 24mm, opening 10mm.

Fits many models, check the list below to see if your model is included before ordering.

This circlip has the following dimensions:

• 25 x 26.9 x 1.2 mm

Hold parts in place with proper locking clips.

So with the right diameter, thickness and made of the right material.

In short, don't take a gamble and install original parts!

Among other things, these bolts are used to hold the two crankcase halves of your engine block together. Do not use worn bolts, because if you damage the threads in your crankcase half by doing so, you will have a big expense on your hands!

Original parts, top service and also low prices = Roger Trading!

This gasket comes between the crankcase halves of the models listed below. Always replace this gasket when disassembling the crankcase, a paper / cardboard gasket cannot be reused!

You find this screw/bolt on a lot of models in different places, so always handy to have a few of them in stock. Always use exactly the right prescribed screws and bolts! They have a certain length and thickness for a reason, and the choice of materials has also been considered.

The oil filter holder of almost all models of Piaggio / Vespa scooters from 125 to 300cc must have this O-ring to prevent leaks.

Check the list at the bottom of the page.