05. Piaggio Zip 50 IGET 4T 3V Euro5 – 25 km/h – 2021-2023 – LBMCD2200 – Parts Cylinder Head

This poppet holds the valve spring in place. You need one per valve, replace them all at once and use only the original ones!

This wedge or locking wedge fixes the valve plate which in turn holds the valve in place Per valve you need one, replace them all at once and use only original parts!

This spring pushes the rocker arm back after the valve is opened. You need one per valve, replace them all at once and use only original parts!

The springs that push back the valves settle against this part, which also holds them neatly in place.

Always use exactly the right and original parts in any engine repair or overhaul.

When mounting the exhaust, you should put a gasket between the mouth of the exhaust and the cylinder, that's better for the environment, performance ánd it makes less noise.

This needle bearing holds the camshaft in place and allows it to turn smoothly. Dimensions:

• outer diameter 13mm
• inner diameter 9mm
• width 8mm

Intake valve for Euro4 and Euro5 models, 50cc. Check the list at the bottom of the page

Dimensions:

• valve diameter 14.7 mm
• length 75.5 mm

Use only original parts in your engine!

Exhaust valve for Euro4 and Euro5 models, 50cc. Check the list at the bottom of the page

Dimensions:

• valve diameter 17.7 mm
• length 75 mm

Use only original parts in your engine!

This needle bearing holds the camshaft in place and allows it to turn smoothly. Dimensions:

• outer diameter 32mm
• inner diameter 25mm
• width 12 mm

This fitting pin is found in almost all Piaggio and Vespa scooters and whatnot. To be sure, check the list at the bottom of the page.

Dimensions:

• outer diameter 7.5 mm
• inner diameter 6.5mm
• length 12 mm

Use only original parts in your engine!

Allen bolt M6x80 mm.

Used to secure the cylinder head of many, many Piaggio, Aprilia and Vespa models.

An original bolt is never wrong!

You will find this nut in many Piaggio, Vespa and Aprilia models. Among others, in the cylinder head, steering column or voltage regulator. Always use exactly the right screws, bolts and nuts! They have a certain length and thickness for a reason, and even the choice of materials has been considered.

The original temperature sensor for the new euro4.euro5 iGet Sprint / Primavera / Zip scooter models. CHECK THE LIST BELOW TO SEE IF YOUR SCOOTER IS INCLUDED.

This socket plug is in the cylinder head to seal an opening through which oil would otherwise come out. Always use original parts in your engine block and avoid unnecessary and expensive damage!

When replacing (or disassembling and reassembling) the cylinder head, you will need to install a new gasket to ensure that no oil, fuel or air can leak into or out of the system.